Guides and Technical Advice
16 October 2026
A simple routine of daily checks, planned servicing and a quick response to faults keeps a high speed door safe and reliable. Here is what to look at and when.
A high speed door can cycle hundreds of times a day. That is what it is built for, but it also means the curtain, guides, drive, sensors and safety devices are working hard. Regular checks catch small problems before they become a stuck door, a safety risk or a production stoppage.
Maintenance is also part of keeping the door compliant. Health and safety law in Great Britain expects workplace doors and equipment to be kept in good working order, as explained in our guide to high speed door safety standards.
These take a minute and do not need a specialist. Watch the door through a full cycle: it should move smoothly and quietly and close fully. Look for a curtain that is torn, creased or out of its guides, a bottom edge that looks damaged, and sensors or photocells that are dirty, misaligned or knocked. Keep the opening clear of pallets and debris, and report anything unusual rather than carrying on. Never test a safety device with your body.
A planned service goes further than a visual check. A trained engineer inspects and tests the curtain and its fixings, the guides and wind bars, the drive, shaft and bearings, the control panel settings and speed, activation devices such as radar sensors, pull cords and remote controls, signal devices such as traffic lights, and safety devices such as photocells, light curtains and safety edges. Worn parts are replaced before they fail.
On doors that work with the blu. app, such as AUTO-FULL®, the app keeps an event history and a maintenance log, which gives the engineer a clear picture of how the door has been behaving between visits.
There is no single answer. It depends on how often the door cycles, the environment it works in, such as dust, cold, wind or washdown, and the manufacturer’s instructions. A door cycling continuously on a busy production line needs attention more often than one used a few times a day. Agree the interval with your service provider, write it into a planned maintenance schedule and keep to it. Our planned servicing and maintenance page explains how GS Doors can help.
Treat any impact, unusual noise, slow or jerky movement or safety-device fault as a reason to act straight away. If the door may be unsafe, stop using it, keep people clear and call for a repair. On AUTO-FULL®, a curtain knocked out of its guides can be repositioned in minutes rather than replaced, which keeps the downtime short. For urgent faults, see our repairs and emergency callout service.
Keep a simple log of each service, each fault and each part replaced. It helps you spot patterns and shows that the door is being looked after. GS Doors holds spare parts in stock with next-day UK delivery, so a worn component does not have to mean a long wait. New GS Doors installations come with a 12-month warranty.
Share this article
Our engineers can help with planned maintenance, repairs and spare parts across the UK.
Request a service